DGLAB_i032_CAN
CANmessage ETH_DAS_STATUS_MID from DAS not received by the UI whilst drive rail ON or Cruise state went to FAULT when Autopilot was activeor
Autopilot state changed from ACTIVE to FAULT
Cruise & Autopilot resume standard operation
Cruise or Autopilot unavailable
Ecall self-test has failed after 3 retries
Ecall self-test has failed after 3 retries. Alert triggers when drive rail turns ON
File /var/run-overlay can alter the behavior of a developer vehicle
Steering module (EPAS3P or EPAS3S) detected a fault or reduced assistance whilst drive rail is on
Steering module (EPAS3P or EPAS3S) detected a fault or reduced assistance whilst drive rail is ON
Steering module (EPAS3P or EPAS3S) resume stabdard operation or drive rail turns OFF
Steering assistance is reduced or inoperational
Display status check failed due to touch device missing.
The /dev/input/touch directory is not accessible.
The /dev/input/touch directory has to be accessible.
Touchscreen is unresponsive or has limited functionality.
Rear trunk open when gear is D/R/N
Shift into Park or close rear trunk or timer of 60 seconds elapsed
Potential danger of open trunk whilst driving
Software running on the modem has crashed (ModemVM)
Navigation map data is missing and the corresponding file system was not mounted. Install latest map data
Navigation map data not found and the corresponding file system mount status is unknown.
Try to install latest map data.
Navigation routing inoperative.
The QtCarVehicle link has stalled. Unable to communicate with vehicle Gateway
file create by H+ 2022 v0325 updater.store