DGLAB_PROC_RADX_XPLANTMODE_1
AssoonasthePROC_RADX_XPLANTMODEroutineissuccessfullyrun, A condition prevents successful CANRX (CAN message received) for the inertial signals message, relating to a checksum, a counter, or an out-of-bounds signal value.
The inertial signals message sent from the driver assistance system (DAS) Electronic Control Unit (ECU) to the radar controller (RADC) ECU is not as expected / as required for the radar to be enabled.
Received Chassis Type Does Not Match Learned Parameter
ECU internal fault - hardware controller error, replace sensor
ECU internal fault - RF Chip Fault,replace Sensor
Hardware / Software Interlock Error - the software programmed on the ECU does not match the hardware revision.
When the software programmed in not compatible with the hardware revision
As soon as the right software is programmed on the ECU
Sensor is disabled due to incompatibility and radar functions will not be available
ECU Internal fault - Memory Built in Self Test Disabled
The radar sensor is blocked, possibly due to environmental factors such as snow, ice, or dirt. There may also be something causing interference between the radar and the secondary surface (fascia), such as the harness being in front of the radar.
The radar has detected a blockage of its sensor / antenna.
file create by H+ 2022 v0325 updater.store