EPAS3S_a132_motFeedFwdCounter25
An internal software assertion has failed.
Electronic Parking Brake is preparing to enter winch mode
Winch mode request has been made.
Winch mode successfully entered, or canceled
Winch mode may not be entered successfully unless customer keeps foot on brake
Electronic Parking Brake was unable to release fully.
Electronic Parking Brake faulted during release && (nonterminal == TRUE)
Electronic Parking Brake attempts a new operation
Electronic Parking Brake may not be released, and caliper may be obstructed
The battery voltage measurement, nominally 12 volts, was lower than expected.
The vbat voltage measurement, is lower than 6.0 volts. If the measurement is lower than 0.25 volts, we do not set this alert, as this would indicated the switch supply is disabled.
Caliper state machine exits csmState CSM_FAULT
12V Battery or low voltage systems may be damaged
Stability Control reports Controlled Deceleration for Parking Brake is not available when car is in DRIVE
Motor negative lead voltage is greater than 6.0 volts while inactive
The Electronic Parking Brake motor is idle, and the negative lead voltage measurement is higher than 6.0 volts.
Caliper motor or harness may be damaged
One or more of the expected CAN messages from ESP were not received.

file create by H+ 2022 v0325 updater.store